Siemens RUGGEDCOM ROX II User Manual page 255

RUGGEDCOM ROX II
CLI User Guide
2. Set the firewall as the working configuration by typing:
security firewall work-config name
Where:
• name is the name of the firewall configuration
Type commit and press Enter to save the changes. The system validates the firewall configuration and
3.
displays the results.
Section 6.9.17
Enabling/Disabling a Firewall
To enable or disable the firewall, do the following:
IMPORTANT!
Enabling or disabling the firewall will reset – but not disable – the BFA protection mechanism, if
previously enabled. Any hosts that were previously blocked will be allowed to log in again. If multiple
hosts are actively attacking at the time, this could result in reduced system performance.
1. Make sure the CLI is in Configuration mode.
2. Enable the firewall by typing:
security firewall enable
Or disable the firewall by using the no version of the command:
no security firewall enable
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Enabling/Disabling a Firewall
Chapter 6
Security
209