Siemens RUGGEDCOM ROX II User Manual page 405

RUGGEDCOM ROX II
CLI User Guide
virtualswitch vs1
retain-ip
no alias
no proxyarp
interface fe-cm-1
!
!
!
If no virtual switches have been configured, add virtual switches as needed. For more information, refer to
Section 12.1.2, "Adding a Virtual
Section 12.1.2
Adding a Virtual Switch
To add a virtual switch, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the virtual switch by typing:
interface virtualswitch name
Where:
• name is the name assigned to the virtual switch
3. Configure the following parameter(s) as required:
Parameter
enabled
retain-ip
forward-delay { forward-delay }
alias { alias }
ip-address-src { ip-address-src }
ipv6-address-src { ipv6-address-src }
proxyarp
4. Add one or more interfaces for the virtual switch. For more information, refer to
Virtual Switch Interface".
Adding a Virtual Switch
Switch".
Synopsis: { true, false }
Default: true
Enables this interface.
Synopsis: { true, false }
Default: false
Retain IP on bridge device.
Synopsis: An 8-bit unsigned integer
Default: 15
Delay (in seconds) of the listening and learning state before goes to forwarding state.
Synopsis: A string 1 to 64 characters long
The SNMP alias name of the interface
Synopsis: { static, dynamic }
Default: static
Whether the IP address is static or dynamically assigned via DHCP or BOOTP.
Synopsis: { static, dynamic }
Default: static
Whether the IPv6 address is static or dynamically assigned via DHCPv6.
Enables/Disables whether the port will respond to ARP requests for hosts other than itself
Tunneling and VPNs
Description
Section 12.1.4.2, "Adding a
Chapter 12
359