Siemens RUGGEDCOM ROX II User Manual page 763

RUGGEDCOM ROX II
CLI User Guide
DSCP COS
--------------
1 normal
3 high
4 medium
6 normal
7 normal
!
If no entries have been configured, add entries as needed. For more information, refer to
"Adding a DSCP-to-CoS Mapping
Section 16.3.3.2
Adding a DSCP-to-CoS Mapping Entry
To add a DSCP-to-CoS mapping entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the entry by typing:
switch class-of-service dscp-to-cos dscp
Where:
• dscp is the value of the 6 bit DiffServ field in the Type-Of-Service (TOS) field of the IP header
3. Configure the following parameter(s) as required:
Parameter
cos { cos }
4. Configure the CoS parameters on select switched Ethernet ports and/or trunk interfaces as needed. For more
information, refer to
Ethernet Trunk
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 16.3.3.3
Deleting a DSCP-to-CoS Mapping Entry
To delete a DSCP-to-CoS mapping entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the entry by typing:
no switch class-of-service dscp-to-cos dscp
Where:
• dscp is the value of the 6 bit DiffServ field in the Type-Of-Service (TOS) field of the IP header
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Adding a DSCP-to-CoS Mapping Entry
Entry".
Synopsis: { N/A, normal, medium, high, crit }
Default: normal
The Class of Service (CoS) assigned to the received frames with the specified DSCP.
Section 8.1.2, "Configuring a Switched Ethernet Port"
Interface".
Traffic Control and Classification
Section 16.3.3.2,
Description
and/or Section 8.2.2, "Adding an
Chapter 16
717