Siemens RUGGEDCOM ROX II User Manual page 720

Chapter 15
Network Discovery and Management
Parameter
unknown-engine-ids
wrong-digests
decryption-errors
Section 15.2.4
Discovering SNMP Engine IDs
To discover an ID of a remote SNMP protocol engine, do the following:
1. At the prompt, type the following command:
admin snmp snmp-discover
2. When prompted, type the IP address of the remote SNMP protocol engine.
ruggedcom# admin snmp snmp-discover
Value for 'address' (<string, min: 7 chars, max: 15 chars>):
Once discovered, the ID is displayed. For example:
snmp-discover-return-string 80:00:3A:9C:03:94:B8:C5:FF:F6:00
Section 15.2.5
Managing SNMP Communities
This section describes how to manage SNMP communities.
CONTENTS
• Section 15.2.5.1, "Viewing a List of SNMP Communities"
• Section 15.2.5.2, "Adding an SNMP Community"
• Section 15.2.5.3, "Deleting an SNMP Community"
674
This parameter is mandatory.
Synopsis: A 32-bit unsigned integer
The total number of packets received by the SNMP engine which were dropped because they
referenced an snmpEngineID that was not known to the SNMP engine.
This parameter is mandatory.
Synopsis: A 32-bit unsigned integer
The total number of packets received by the SNMP engine which were dropped because they
did not contain the expected digest value.
This parameter is mandatory.
Synopsis: A 32-bit unsigned integer
The total number of packets received by the SNMP engine which were dropped because they
could not be decrypted.
This parameter is mandatory.
Description
ip-address
Discovering SNMP Engine IDs
RUGGEDCOM ROX II
CLI User Guide