Siemens RUGGEDCOM ROX II User Manual page 259

RUGGEDCOM ROX II
CLI User Guide
Parameter
bytes
packets
errors
dropped
collisions
Section 7.1.3
Managing IPv4 Addresses
This section describes how to manage IPv4 addresses for a routable interface.
CONTENTS
• Section 7.1.3.1, "Viewing a List of IPv4 Addresses"
• Section 7.1.3.2, "Adding an IPv4 Address"
• Section 7.1.3.3, "Deleting an IPv4 Address"
Section 7.1.3.1
Viewing a List of IPv4 Addresses
To view a list of IPv4 address for a routable interface, type:
show running-config ip interface ipv4
Where:
• interface is the name of the interface
If addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config ip ipv4 | tab
IFNAME IPADDRESS
-------------------------------------
dummy0
1.1.1.1/32
fe-cm-1
Managing IPv4 Addresses
This parameter is mandatory.
Synopsis: A 64-bit unsigned integer
The number of bytes transmitted.
This parameter is mandatory.
Synopsis: A 64-bit unsigned integer
The number of packets transmitted.
This parameter is mandatory.
Synopsis: A 32-bit unsigned integer
The number of error packets transmitted.
This parameter is mandatory.
Synopsis: A 32-bit unsigned integer
The number of packets dropped by the transmitting device.
This parameter is mandatory.
Synopsis: A 32-bit unsigned integer
The number of collisions detected on the port.
This parameter is mandatory.
PEER
-
IP Address Assignment
Description
Chapter 7
213