Siemens RUGGEDCOM ROX II User Manual page 594

Chapter 13
Unicast and Multicast Routing
Parameter
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.10.5.4
Deleting a Static Label
To delete a static label, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete a static label by typing:
no mpls static-mpls binding [ ipv4 | ipv6 ] dest-address address
Where:
• address is the destination address and prefix.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.10.6
Managing Static Cross-Connects
Configure MPLS static cross-connects when the device is the core MPLS router. Cross-connects build Label Switch
Paths (LSPs) when neighboring routers do not deploy the Label Distribution Protocol (LDP). The entry for static
cross-connects is added to the Label Forwarding Information Base (LFIB). And, as such, label binding is not
required in the Label Information Base (LIB).
CONTENTS
• Section 13.10.6.1, "Viewing the Status of Static Cross-Connects"
• Section 13.10.6.2, "Viewing a List of Static Cross-Connects"
• Section 13.10.6.3, "Adding a Static Cross-Connect"
• Section 13.10.6.4, "Deleting a Static Cross-Connect"
Section 13.10.6.1
Viewing the Status of Static Cross-Connects
To view the status of all configured static cross-connects, type:
show mpls status static-crossconnect
If static cross-connects have been configured, a table similar to the following example appears:
ruggedcom# show mpls status static-crossconnect
LOCAL OUTGOING
548
• explicit null - The label has a value of 0, meaning that, in place of a pop operation, the
OUTGOING
router. Penultimate Hop Popping (PHP) reduces the number of label lookups that need
to be performed by the egress router
penultimate (next-to-last) router forwards an IPv4 packet with an outgoing MPLS label
of 0 to the egress router
Description
Deleting a Static Label
RUGGEDCOM ROX II
CLI User Guide