Siemens RUGGEDCOM ROX II User Manual page 285

RUGGEDCOM ROX II
CLI User Guide
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
8.
Section 7.3.8.4
Deleting a Subnet
To delete a subnet, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the subnet by typing:
• For IPv4
no services dhcpserver subnet-name name
• For IPv6
no services dhcpserver6 subnet6-name name
Where:
• name is the name of the subnet
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 7.3.9
Managing Host Groups
Host-groups allow identical settings to be created for a group of hosts, making it easier to manage changes to the
settings for all the hosts contained within the group. Host-groups contain hosts.
CONTENTS
• Section 7.3.9.1, "Viewing a List of Host Groups"
• Section 7.3.9.2, "Adding a Host Group"
• Section 7.3.9.3, "Configuring Host Group Options"
• Section 7.3.9.4, "Deleting a Host Group"
Section 7.3.9.1
Viewing a List of Host Groups
To view a list of host groups, type:
• For IPv4
show running-config services dhcpserver host-groups
• For IPv6
show running-config services dhcpserver6 host-groups
If host groups have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver host-groups
services
dhcpserver
host-groups "Local Group"
Deleting a Subnet
Chapter 7
IP Address Assignment
239