Siemens RUGGEDCOM ROX II User Manual page 124

Chapter 4
Device Management
show running-config admin logging server
If remote servers have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin logging server
admin
logging
server 172.30.144.254
enabled
selector 1
no negate
facility-list [ all ]
!
!
!
!
If no remote servers have been configured, add servers as needed. For more information, refer to
Section 4.10.5.2, "Adding a Remote
Section 4.10.5.2
Adding a Remote Server
To add a remote server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the remote server by typing:
admin logging server address
Where address is the IP address of the remote server.
3. Configure the following parameter(s) as required:
Parameter
enabled
transport { transport }
monitor-interface { monitor-interface }
port { port }
4. Configure one or more selectors for the server. For more information, refer to
Remote Server
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
78
Server".
Enables/disables the feed to the remote logging server.
Synopsis: { udp, tcp }
Default: udp
TCP or UDP.
Synopsis: A string
The interface to monitor. If the IP address is changed on the interface, the logging
daemon will restart.
Synopsis: A 16-bit unsigned integer between 1 and 65535
Default: 514
Port number.
Selector".
Description
Section 4.10.6.2, "Adding a
Adding a Remote Server
RUGGEDCOM ROX II
CLI User Guide