Siemens RUGGEDCOM ROX II User Manual page 77

RUGGEDCOM ROX II
CLI User Guide
Parameter
repeat
save
select
tab
until
Using Output Redirects
lm4 E1 w/ 2x BNC
lm5 none
lm6 none
power-controller
PM MOV PM
SLOT PROTECTION TEMPERATURE
------------------------------------------------
pm1 na 43
For example, show chassis | begin line-modules | notab suppresses the table formatting:
ruggedcom# show chassis | begin line-modules | notab
line-modules
line-module lm1
detected module "1000TX w/ 2x RJ45"
line-module lm2
detected module none
line-module lm3
detected module "6x RS232/RS422/RS485 via RJ45"
line-module lm4
detected module "E1 w/ 2x BNC"
line-module lm5
detected module none
line-module lm6
detected module none
power-controller
PM MOV PM
SLOT PROTECTION TEMPERATURE
------------------------------------------------
pm1 na 43
Repeats the term at the specified interval. Specify an interval in seconds. The term repeats
until you cancel it with Ctrl-C.
For example, show admin | repeat 10s repeats the show admin term every 10 seconds.
Saves the output to the specified ASCII text file.
For example, show chassis | save foo.txt saves the chassis information to the file foo.txt
This redirect is not yet implemented.
Enforces table layout for columnar data.
Includes output until a line containing the specified text appears. Regular expressions
can be used with this redirect. For more information about regular expressions, refer to
Section 2.5.7, "Using Regular Expressions".
For example, show chassis | begin cpu | until status returns the chassis information
beginning with cpu and ending with status:
ruggedcom# show chassis | begin cpu | until status
cpu
slot-cpu main
detected module "RX1501 8 Gigabit Layer 3 w/ 6 LM slots and 1 PM
slots"
cpu load 22
ram avail 53
ram avail low 20
status
Using RUGGEDCOM ROX II
Description
- -
- -
- -
PM PM
CURRENT VOLTAGE
2907 3381
PM PM
CURRENT VOLTAGE
2892 3381
Chapter 2
31