Siemens RUGGEDCOM ROX II User Manual page 102

Chapter 4
Device Management
model
software license
order code
rox release
system serial number RX5000R-0812-00664
This table or list provides the following information:
Parameter
model
software-license
rox-release
system-serial-number
last-integrity-check
last-integrity-check-result
Section 4.2
Viewing Chassis Information and Status
This section describes how to view information about the device chassis, such as its configuration and operating
status.
CONTENTS
• Section 4.2.1, "Viewing the Slot Hardware"
• Section 4.2.2, "Viewing Module Information"
• Section 4.2.3, "Viewing Flash Card Storage Utilization"
• Section 4.2.4, "Viewing CPU/RAM Utilization"
• Section 4.2.5, "Viewing the Slot Status"
• Section 4.2.6, "Viewing the Slot Sensor Status"
• Section 4.2.7, "Viewing the Power Controller Status"
Section 4.2.1
Viewing the Slot Hardware
To view a list of the hardware installed in each slot, type:
56
RX5000
"Layer 3 Standard Edition"
RX5000-L3-MNT-HI-L3SE-CG01-XX-S01-E02-XX-XX
"ROX 2.6.0-QA3.14 (2014-08-11 18:00)"
Synopsis: A string
The RuggedCom device model name.
Synopsis: A string
The current software capability.
Synopsis: A string
The release of ROX running on the chassis.
This parameter is mandatory.
Synopsis: A string 1 to 32 characters long
The system serial number on the chassis label.
This parameter is mandatory.
Synopsis: A string 1 to 32 characters long
The last time the firmware integrity was checked.
Synopsis: A string
The result of the last integrity check.
Description
Viewing Chassis Information and Status
RUGGEDCOM ROX II
CLI User Guide