Siemens RUGGEDCOM ROX II User Manual page 584

Chapter 13
Unicast and Multicast Routing
Section 13.9.9.1
Viewing a List of Routing Interfaces
To view a list of routing interfaces for an OSPF network, type:
• For Standard OSPF Routes
show running-config routing ospf interface
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf interface
Where:
• vrf is the name of the chosen VRF
A table or list similar to the following example appears:
ruggedcom# show running-config routing ospf interface | tab
TRANSMIT KEY
IFNAME AUTHENTICATION
ID MD5
---------------------------------------------------------------------------------------------
dummy0 -
fe-cm-1 -
switch.0001 -
Section 13.9.9.2
Configuring a Routing Interface
To configure a routing interface for an OSPF network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to either:
• For Standard OSPF Routes
routing » dynamic » ospf » interface » {name}
• For VRF Routes via OSPF
routing » dynamic » ospf » vrf » {vrf} » interface » {name}
Where:
• {vrf} is the chosen VRF
• {name} is the name of the interface
3. Configure the dead interval settings by typing the following commands:
NOTE
For reliable operation, it is recommended that the dead-interval value be at least four times
the number of Hellos per second.
NOTE
Lower values of dead-interval and minimal-hello-multiplier will help speed up the
change in network routes when the topology of the network changes. It will also increase the load
on the router and the links, due to higher traffic caused by the increase in messages.
538
MINIMAL
DEAD HELLO
COST INTERVAL MULTIPLIER
- 40 -
- 40 -
- 40 -
HELLO
INTERVAL PRIORITY PASSIVE
10 1 true
10 1 true
10 1 true
Viewing a List of Routing Interfaces
RUGGEDCOM ROX II
CLI User Guide
RETRANSMIT
INTERVAL DELAY
5 1
5 1
5 1