Siemens RUGGEDCOM ROX II User Manual page 477

RUGGEDCOM ROX II
CLI User Guide
Section 12.10.2
Configuring DMVPN
To configure the device to act as a spoke in a hub-and-spoke network, do the following:
NOTE
RUGGEDCOM ROX II supports connections with up to two hubs.
1. Determine the static IP address of the hub router.
2. Configure a GRE tunnel to the hub. For more information, refer to
3. Configure IPsec for the GRE tunnel, making sure the connection name matches the name of the GRE interface
(e.g. gre-t1). For more information, refer to
4. Configure a BGP route for the GRE tunnel. For more information, refer to
5. Enable the DMVPN service by typing:
services nhrp enabled
NOTE
RUGGEDCOM ROX II supports up to two DMVPN interfaces, each of which can be assigned to
different GRE tunnels.
6. Configure a DMVPN interface for each GRE tunnel. For more information, refer to
a DMVPN Interface".
7. Configure an IPsec/GRE tunnel from the hub to the device, using the IP address defined for the device's
DMVPN interface.
8. Verify the status of the DMVPN connection. For more information, refer to
Status of DMVPN".
Section 12.10.3
Managing DMVPN Interfaces
Configure a DMVPN interface to connect with a host. Up to two interfaces can be configured, allowing the device
to connect with two hubs.
CONTENTS
• Section 12.10.3.1, "Viewing a List of DMVPN Interfaces"
• Section 12.10.3.2, "Adding a DMVPN Interface"
• Section 12.10.3.3, "Deleting a DMVPN Interface"
Section 12.10.3.1
Viewing a List of DMVPN Interfaces
To view a DMVPN interfaces, type:
show running-config services nrhp interface-nhrp
Configuring DMVPN
Section 12.7.3, "Adding a GRE
Section 12.8.2, "Configuring IPsec
Tunneling and VPNs
Tunnels".
Section 13.8.1, "Configuring
Section 12.10.3.2, "Adding
Section 12.10.4, "Viewing the
Chapter 12
Tunnel".
BGP".
431