Siemens RUGGEDCOM ROX II User Manual page 407

RUGGEDCOM ROX II
CLI User Guide
!
!
If no virtual switch interfaces have been configured, add interfaces as needed. For more information, refer to
Section 12.1.4.2, "Adding a Virtual Switch
Section 12.1.4.2
Adding a Virtual Switch Interface
To add a virtual switch interface, do the following:
IMPORTANT!
At least two interfaces are required for a virtual switch bridge.
CAUTION!
Accessibility hazard – risk of access disruption. Do not select the interface used to the access the Web
interface. Active Web sessions will be lost and the Web interface will be unreachable until the virtual
switch is disabled.
NOTE
The wlan-cl1 interface is not supported as a virtual switch interface.
1. Make sure the CLI is in Configuration mode.
2. Add an interface to the virtual switch by typing:
interface virtualswitch name interface interface
Where:
• name is the name assigned to the virtual switch
• interface is the name assigned to the interface
The new interface is now accessible by typing:
ip vsw-name
The new virtual switch is now visible under the ip menu with the prefix vsw- (i.e. vsw-vs1, vsw-vs2, etc.).
3. Assign an IPv4 or IPv6 address to the interface. For more information, refer to
IPv4 Address" or
4. If necessary, add one or more VLANs to the virtual switch interface. For more information, refer to
Section 12.1.8.2, "Adding a Virtual Switch
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 12.1.4.3
Deleting a Virtual Switch Interface
To delete a virtual switch interface, do the following:
1. Make sure the CLI is in Configuration mode.
Adding a Virtual Switch Interface
Interface".
Section 7.1.4.2, "Adding an IPv6 Address".
VLAN".
Tunneling and VPNs
Section 7.1.3.2, "Adding an
Chapter 12
361