Siemens RUGGEDCOM ROX II User Manual page 238

Chapter 6
Security
1. Make sure the CLI is in Configuration mode.
2. Add the zone by typing:
security firewall fwconfig firewall fwzone zone
Where:
• firewall is the name of the firewall
• zone is the name of the zone
3. Configure the following parameter(s) as required:
Parameter
iptype { iptype }
type46 { type46 }
type6 { type6 }
type { type }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 6.9.9.3
Deleting a Zone
To delete a zone, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the zone by typing:
no security firewall fwconfig firewall fwzone name
Where:
• firewall is the name of the firewall
• name is the name of the zone
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
192
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used, otherwise define IPv4 and
IPv6 rules for each type of addresses used.
Synopsis: { ip, ipsec, firewall }
Default: ip
Zone types applying to both IPv4 and IPv6: plain IP, firewall, or IPSec
Synopsis: { ipv6, ipsec, firewall }
Default: ipv6
Zone types are plain IPv6, firewall, or IPSec
Synopsis: { ipv4, ipsec, firewall }
Default: ipv4
Zone types are plain IPv4, firewall, or IPSec
Synopsis: A string
(Optional) The description string for this zone
Description
RUGGEDCOM ROX II
CLI User Guide
Deleting a Zone