Siemens RUGGEDCOM ROX II User Manual page 493

RUGGEDCOM ROX II
CLI User Guide
Section 13.6.5.1
Viewing a List of Area Tags
To view a list of area tags configured for dynamic IS-IS routes, type:
show running-config routing isis area
If area tags have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing isis area
routing isis
area Area_1
is-type
metric-style
area-authorization
area-password
area-authentication
domain-authorization
domain-password
domain-authentication validate
net 49.0001.1921.6800.1001.00
!
redistribute bgp
is-type level-1-2
metric-type internal
metric 10
!
lsp-gen-interval is-type level-1-only
interval 60
!
lsp-refresh-interval is-type level-1-2
interval 20
!
max-lsp-lifetime is-type level-2-only
interval 10
!
spf-interval is-type level-1-2
interval 5
!
!
!
If no area tags have been configured, add area tags as needed. For more information, refer to
"Adding an Area Tag".
Section 13.6.5.2
Adding an Area Tag
To add an area tag for dynamic IS-IS routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the area by typing:
routing isis area name
Where:
• name is the unique name for a routing process that belongs to a specific router.
3. Configure the following parameter(s) as required:
Viewing a List of Area Tags
level-1-2
narrow
md5
admin
validate
md5
admin
Chapter 13
Unicast and Multicast Routing
Section 13.6.5.2,
447