Siemens RUGGEDCOM ROX II User Manual page 747

RUGGEDCOM ROX II
CLI User Guide
Parameter
out-unit { out-unit }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 16.2.5.3
Deleting a Traffic Control Device
To delete a traffic control device, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control device by typing:
no qos traffic-control advanced-configuration tcdevices name
Where:
• name is the name of the interface to which traffic shaping will apply.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 16.2.6
Managing Traffic Control Rules
Traffic control rules define rules for packet marking.
NOTE
Traffic control rules can only be configured in advanced mode. For more information about setting the
traffic control mode, refer to
CONTENTS
• Section 16.2.6.1, "Viewing a List of Traffic Control Rules"
• Section 16.2.6.2, "Adding a Traffic Control Rule"
• Section 16.2.6.3, "Configuring QoS Marking"
• Section 16.2.6.4, "Deleting aTraffic Control Rule"
Deleting a Traffic Control Device
Maximum outgoing bandwidth... This is the maximum speed that can be handled.
Additional packets will be dropped. This is the bandwidth that can be refrred-to as 'full'
when defining classes.
This parameter is mandatory.
Synopsis: { kilobits, megabits }
Default: megabits
Unit for outgoing bandwidth, per second.
Synopsis: A string
A description for this configuration item.
Section 16.2.1, "Enabling and Configuring Traffic
Traffic Control and Classification
Description
Control".
Chapter 16
701