Siemens RUGGEDCOM ROX II User Manual page 516

Chapter 13
Unicast and Multicast Routing
Section 13.7.6.1
Viewing a List of Network Interfaces
To view a list of interfaces configured for a RIP network, type:
show running-config routing rip network interface
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip network interface
routing rip
network interface switch.4084
!
!
If no interfaces have been configured, add neighbors as needed. For more information, refer to
"Adding a Neighbor".
Section 13.7.6.2
Adding a Network Interface
To add an interface for a RIP network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the neighbor by typing:
routing rip network interface name
Where:
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.7.6.3
Deleting a Network Interface
To delete an interface from a RIP network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the network by typing:
no routing rip network interface name
Where:
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
470
RUGGEDCOM ROX II
CLI User Guide
Section 13.7.7.2,
Viewing a List of Network Interfaces