Siemens RUGGEDCOM ROX II User Manual page 241

RUGGEDCOM ROX II
CLI User Guide
7. Configure a broadcast address for the interface. For more information configuring a broadcast address, refer
to Section 6.9.10.4, "Configuring a Broadcast
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
8.
Section 6.9.10.3
Associating an Interface with a Zone
To associate an interface with a pre-defined zone or mark the associated zone as undefined, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to security » firewall » fwconfig » {firewall} » fwinterface{interface} » zone, where {firewall} is
the name of the firewall and {interface} is the name of the interface.
3. Configure the following parameter(s) as required:
Parameter
predefined-zone { predefined-zone }
undefined-zone
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 6.9.10.4
Configuring a Broadcast Address
To configure a broadcast address for an interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to security » firewall » fwconfig » {firewall} » fwinterface{interface} » broadcast-addr, where
{firewall} is the name of the firewall and {interface} is the name of the interface.
3. Configure the following parameter(s) as required:
Parameter
ipv4-address { ipv4-address }
detect
none
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 6.9.10.5
Deleting an Interface
To delete an interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
Associating an Interface with a Zone
Address".
Synopsis: A string
A pre-defined zone
This is used in conjunction with hosts definitions.
Synopsis: A string
An IPv4 address for a broadcast address.
Automatic detection of the broadcast address(es).
The default.
Description
Description
Chapter 6
Security
195