Siemens RUGGEDCOM ROX II User Manual page 600

Chapter 13
Unicast and Multicast Routing
PEER ID PEER IP
-----------------------------------------------------------------------
2.2.2.2 192.168.10.1
6.6.6.6 192.168.20.2
This table or list provides the following information:
Parameter
peer-id
peer-ip
interface
local-ip
peer-hello-holdtime
agreed-hello-holdtime
peer-session-holdtime
Section 13.10.7.6
Configuring LDP
To configure the LDP, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable the LDP by typing the following commands:
Enable
mpls ldp enable
Disable
no mpls ldp enable
3. Configure the following parameter(s) as required:
Parameter
enabled
holdtime { holdtime }
554
INTERFACE LOCAL IP
switch.0010 192.168.10.2
switch.0020 192.168.20.1
Synopsis: A string
The peer ID of the LDP neighbor discovery.
Synopsis: A string
The peer ID of the LDP neighbor discovery.
Synopsis: A string
The local IP address of the LDP neighbor discovery.
Synopsis: A string
LDP neighbor discovery state.
Synopsis: A string
The peer hello holdtime of the LDP neighbor discovery.
Synopsis: A string
The agreed upon hello holdtime (shorter holdtime of local/peer) of the LDP neighbor
discovery.
Synopsis: A string
The peer session holdtime of the LDP neighbor discovery.
Synopsis: { true, false }
Default: false
A boolean flag to indicate that Label Distribution Protocol (LDP) is enabled.
Synopsis: A 32-bit unsigned integer
Default: 180
P KEEPALIVE
HOLDTIME INTERVAL
15s 180s
15s 180s
Description
Description
RUGGEDCOM ROX II
CLI User Guide
Configuring LDP