Siemens RUGGEDCOM ROX II User Manual page 769

RUGGEDCOM ROX II
CLI User Guide
2. Add the interface by typing:
services netflow interface interface direction direction
Where:
• interface is the desired interface
• direction is the direction of traffic to be monitored. Options include:
▫ ingress – Only traffic entering through the interface is monitored
▫ egress – Only traffic exiting through the interface is monitored
▫ both – All traffic traversing the interface is monitored
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 16.4.7.3
Deleting a NetFlow Interface
To delete a NetFlow interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
no services netflow interface interface
Where interface is the desired interface.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 16.4.8
Managing NetFlow Collectors
RUGGEDCOM ROX II can be configured to forward flows to up to four NetFlow collectors.
CONTENTS
• Section 16.4.8.1, "Viewing a List of NetFlow Collectors"
• Section 16.4.8.2, "Adding a NetFlow Collector"
• Section 16.4.8.3, "Enabling/Disabling a NetFlow Collector"
• Section 16.4.8.4, "Deleting a NetFlow Collector"
Section 16.4.8.1
Viewing a List of NetFlow Collectors
To view a list of NetFlow collectors the device can send flows, type:
show running-config services netflow collector
If collectors have been configured, a table or list similar to the following example appears:
show running-config services netflow collector | tab
Deleting a NetFlow Interface
Chapter 16
Traffic Control and Classification
723