Siemens RUGGEDCOM ROX II User Manual page 579

RUGGEDCOM ROX II
CLI User Guide
• For VRF Routes via OSPF
no routing ospf vrf vrf filter route-map tag
Where:
• vrf is the name of the chosen VRF
• tag is the tag for the route map filter
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.9.6.6
Deleting a Route Map Filter Entry
To delete an entry for a route map filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the filter key by typing:
• For Standard OSPF Routes
no routing ospf filter route-map tag entry number
• For VRF Routes via OSPF
no routing ospf vrf vrf filter route-map tag entry number
Where:
• vrf is the name of the chosen VRF
• tag is the tag for the route map filter
• number is the sequence number for the entry
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.9.6.7
Configuring Match Rules
To configure match rules for a route map filter entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to either:
• For Standard OSPF Routes
routing » dynamic » ospf » filter » route-map » {tag} » entry » {number} » match
• For VRF Routes via OSPF
routing » dynamic » ospf » vrf » {vrf} » filter » route-map » {tag} » entry » {number} » match
Where:
• {vrf} is the chosen VRF
• {tag} is the tag for the route map filter
• {number} is the sequence number for the entry
3. Configure the following parameters as required:
Deleting a Route Map Filter Entry
Chapter 13
Unicast and Multicast Routing
533