Siemens RUGGEDCOM ROX II User Manual page 639

RUGGEDCOM ROX II
CLI User Guide
NOTE
A default routing protocol with a local address of 169.254.0.1 always appears when the show
routing status pim-sm command is run. This internal routing protocol is a placeholder to
reserve the source-specific multicast address range.
ruggedcom# show routing status pim-sm
routing status pim-sm
bsr 1.1.1.1
vinterface
LOCAL
INDEX ADDRESS
---------------------------------------------------------------
0 192.168.0.12
1 169.254.72.4
2 1.1.1.1
3 169.254.0.1
4 192.168.11.1
5 192.168.12.1
6 192.168.14.1
rp
ID PREFIX
--------------------------------------------
3.3.3.3
225.0.0.1/32
225.0.0.2/32
Parameter
index
local-address
subnet
flags
Section 13.14.3
Viewing the Status of Dynamic Multicast Routing
To view the status of dynamic multicast routing, type:
show routing status multicast
Viewing the Status of Dynamic Multicast Routing
SUBNET FLAGS
192.168.0.0/24 DISABLED
169.254.72.0/28 DISABLED
1.1.1.1/32 DR NO-NBR
169.254.0.0/24 DISABLED
192.168.11.0/24 DR NO-NBR
192.168.12.0/24 PIM
192.168.14.0/24 PIM
PRIORITY HOLDTIME
1 105
1 105
Synopsis: A 32-bit unsigned integer
Virtual interface index.
Synopsis: A string 1 to 16 characters long
Local address.
Synopsis: A string 1 to 20 characters long
Subnet.
Synopsis: A string 1 to 128 characters long
Flags indicates virtual interface information.
• DISABLED: The virtual interface is administratively disabled for PIM-SM.
• DOWN: This virtual interface is down.
• DR: Designated router.
• NO-NBR: No neighbor on this virtual interface.
• PIM: PIM neighbor.
• DVMRP: DVMRP neighbor.
ID
192.168.12.2
192.168.14.4
Description
Chapter 13
Unicast and Multicast Routing
593