Siemens RUGGEDCOM ROX II User Manual page 356

Chapter 8
Layer 2
Section 8.5.4
Managing VLANs for Switched Ethernet Ports
This section describes how to configure and manage VLANs assigned to switched Ethernet ports.
CONTENTS
• Section 8.5.4.1, "Viewing VLAN Assignments for Switched Ethernet Ports"
• Section 8.5.4.2, "Configuring VLANs for Switched Ethernet Ports"
Section 8.5.4.1
Viewing VLAN Assignments for Switched Ethernet Ports
To determine which VLANs are assigned to each switched Ethernet port, type:
show switch vlans vlan-summary
A table similar to the following example appears:
ruggedcom# show switch vlans vlan-summary
IGMP
VID SNOOPING MSTI
-------------------------------------------------------------------------
1 false 0
.
.
.
The VLANs listed are based on the PVIDs assigned to the switched Ethernet ports. For more information about
assigning PVIDs to switched Ethernet Ports, refer to
Section 8.5.4.2
Configuring VLANs for Switched Ethernet Ports
When a VLAN ID is assigned to a switched Ethernet port, the VLAN appears in the All-VLANs Table where it can be
further configured.
To configure a VLAN for a switched Ethernet port, do the following:
310
UNTAGD UNTAGD TAGGED
SLOT PORTS SLOT
sm none
lm1 1,2
lm2 none
lm3 none
lm4 none
lm5 none
lm6 none
sm
lm1
lm2
lm3
lm4
lm5
lm6
TAGGED
PORTS QOS INGRESS
none
none
none
none
none
none
none
0 0
1 0
2 0
3 0
4 0
Section 8.1.2, "Configuring a Switched Ethernet
MARK
Managing VLANs for Switched Ethernet Ports
RUGGEDCOM ROX II
CLI User Guide
Port".