Siemens RUGGEDCOM ROX II User Manual page 482

Chapter 13
Unicast and Multicast Routing
192.168.0.0/24
This table/list provides the following information:
Parameter
destination
gateway
interface
type
weight
metric
If no IPv4 routes have been configured, add routes as needed. For more information, refer to
"Adding an IPv4 Address".
Section 13.2
Viewing the Status of IPv6 Routes
To view the status of the IPv6 routes configured on the device, type:
show routing status ipv6routes
If IPv6 routes have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status ipv6routes
DESTINATION GATEWAY
-----------------------------------------------------------
fe80:/64
fe80:/64
fe80:/64
fe80:/64
fe80:/64
fe80:/64
ff00:/8
ff00:/8
ff00:/8
ff00:/8
ff00:/8
ff00:/8
This table/list provides the following information:
Parameter
destination
gateway
436
switch.0001 kernel
Synopsis: A string
The network/prefix.
Synopsis: A string
The gateway address.
Synopsis: A string
The interface name.
Synopsis: A string
The route type.
Synopsis: A string
The route weight.
Synopsis: A string
The route metric value.
INTERFACE TYPE
switch kernel
dp1 kernel
vrf_lo kernel
switch.0001 kernel
fe-cm-1 kernel
switch.4094 kernel
switch
dp1
vrf_lo
switch.0001
fe-cm-1
switch.4094
Synopsis: A string
The network/prefix.
Synopsis: A string
Description
WEIGHT METRIC
256
256
256
256
256
256
256
256
256
256
256
256
Description
RUGGEDCOM ROX II
CLI User Guide
Section 7.1.3.2,
Viewing the Status of IPv6 Routes