Siemens RUGGEDCOM ROX II User Manual page 414

Chapter 12
Tunneling and VPNs
Section 12.1.7.2
Adding an In/Out Interface
To add an in/out interface that can be used by a virtual switch filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the in/out interface by typing:
security virtualswitch-filter virtualswitch name rule rule [ in-interface | out-interface ]
interface
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
• interface is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.1.7.3
Deleting an In/Out Interface
To delete an in/out interface that can be used by a virtual switch filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
no security virtualswitch-filter virtualswitch name rule rule [ in-interface | out-interface ]
interface
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
• interface is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.1.8
Managing VLANs for Virtual Switches
This section describes how to configure and manage VLANs for virtual switches.
CONTENTS
• Section 12.1.8.1, "Viewing a List of Virtual Switch VLANs"
• Section 12.1.8.2, "Adding a Virtual Switch VLAN"
• Section 12.1.8.3, "Deleting a Virtual Switch VLAN"
368
RUGGEDCOM ROX II
CLI User Guide
Adding an In/Out Interface