Siemens RUGGEDCOM ROX II User Manual page 660

Chapter 14
Network Redundancy
Section 14.1.8.1
Viewing a List of Track Scripts
To view a list of track scripts, type:
show running-config services vrrp instance name monitor
Where:
• name is the name of the VRRP instance
If track scripts have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services vrrp instance track-script
services
vrrp
instance vid20
track-script tracker1
!
!
!
!
If no VRRP monitors have been configured, add monitors as needed. For more information, refer to
Section 14.1.7.2, "Adding a VRRP
Section 14.1.8.2
Adding a Track Script
To add a track script, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the track script by typing:
services vrrp instance name track-script tracker
Where:
• name is the name of the VRRP instance
• tracker is the name of the tracker to use to monitor the VRRP instance
3. Configure the following parameter(s) as required:
Parameter
weight { weight }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 14.1.8.3
Deleting a Track Script
To delete a track script, do the following:
1. Make sure the CLI is in Configuration mode.
614
Monitor".
Synopsis: A 32-bit signed integer between -254 and 254
This setting overwrites the weight setting in the tracker. If negative, the priority
decreases by this amount when the tracker falls. If positive, the priority increases by this
amount when the tracker rises. If not set, the weight value in the tracker will be used.
Description
Viewing a List of Track Scripts
RUGGEDCOM ROX II
CLI User Guide