Siemens RUGGEDCOM ROX II User Manual page 413

RUGGEDCOM ROX II
CLI User Guide
1. Make sure the CLI is in Configuration mode.
2. Delete the filter by typing:
no security virtualswitch-filter virtualswitch name rule rule
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.1.7
Managing In/Out Interfaces
In/out interfaces for virtual switch filters represent the interface being monitored by the filter (in interface) and the
destination interface (out interface) for network traffic that meets the filter's criteria.
CONTENTS
• Section 12.1.7.1, "Viewing a List of In/Out Interfaces"
• Section 12.1.7.2, "Adding an In/Out Interface"
• Section 12.1.7.3, "Deleting an In/Out Interface"
Section 12.1.7.1
Viewing a List of In/Out Interfaces
To view a list of in/out interfaces that can be used by a virtual switch filter, type:
show running-config security virtualswitch-filter virtualswitch name rule rule [ in-interface | out-
interface ]
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
If in/out interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security virtualswitch-filter virtualswitch vs1 rule in-interface | tab
NAME NAME
--------------------
ipv6
switch.0010
iso
switch.0010
goose
switch.0010
!
!
!
If no in/out interfaces have been configured, add interfaces as needed. For more information, refer to
Section 12.1.7.2, "Adding an In/Out
Managing In/Out Interfaces
Interface".
Chapter 12
Tunneling and VPNs
367