Siemens RUGGEDCOM ROX II User Manual page 613

RUGGEDCOM ROX II
CLI User Guide
NOTE
VRF maintains a table listing each interface belonging to each IP/VPN tunnel.
CONTENTS
• Section 13.11.8.1, "Viewing a List of IP/VPN Tunnels"
• Section 13.11.8.2, "Adding an IP/VPN Tunnel"
• Section 13.11.8.3, "Deleting an IP/VPN Tunnels"
Section 13.11.8.1
Viewing a List of IP/VPN Tunnels
To view a list of IP/VPN tunnels configured for VRF, type:
show running-config routing bgp address-family vpnv4
A table or list similar to the following example appears:
ruggedcom# show running-config routing bgp address-family vpnv4 | tab
routing bgp
address-family vpnv4
neighbor
SEND
IP COMMUNITY
--------------------
1.2.6.2 both
!
!
Section 13.11.8.2
Adding an IP/VPN Tunnel
To add a new IP/VPN tunnel for VRF, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the neighbor by typing:
routing bgp address-family vpnv4 neighbor address
Where:
• address is the IP address of the neighbor
3. [Optional] Set the send community by typing:
send-community [ both | extended | none | standard ]
4. [Optional] Enable the IP/VPN tunnel as a VPNv4 route reflector client by typing:
route-reflector-client enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Viewing a List of IP/VPN Tunnels
Chapter 13
Unicast and Multicast Routing
567