Siemens RUGGEDCOM ROX II User Manual page 346

Chapter 8
Layer 2
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 8.4.5.3
Deleting an Egress Port
To delete an egress port for a static multicast group defined in the Static Multicast Group Summary table, do the
following:
1. Make sure the CLI is in Configuration mode.
2. Delete the table entry by typing:
no switch mcast-filtering static-mcast-table id address egress-ports slot port
Where:
• id is the ID for the VLAN upon which the static multicast group operates
• address is the MAC address for the device in the form of 01:xx:xx:xx:xx:xx
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 8.4.6
Viewing a Summary of Multicast Groups
To view a summary of all multicast groups, type:
show switch mcast-filtering mcast-group-summary
If multicast groups have been configured, a table or list similar to the following example appears:
ruggedcom# show switch mcast-filtering mcast-group-summary
VID MAC
-----------------------------------------------------
10 01:00:00:01:01:01
This table or list provides the following information:
Parameter
vid
mac
300
STATIC STATIC GMRP
SLOT PORTS SLOT
lm1 4
Synopsis: A 32-bit signed integer
The VLAN Identifier of the VLAN upon which the multicast group operates.
Synopsis: A string 17 characters long
The multicast group MAC address.
GMRP
PORTS
Description
RUGGEDCOM ROX II
CLI User Guide
Deleting an Egress Port