Siemens RUGGEDCOM ROX II User Manual page 246

Chapter 6
Security
Parameter
4. Configure the source zone for the policy. For more information, refer to
Source Zone".
5. Configure the destination zone for the policy. For more information, refer to
the Destination
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 6.9.12.3
Configuring the Source Zone
To configure the source zone for a firewall policy, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to security » firewall » fwconfig » {firewall} » fwpolicy » {policy} » source-zone, where {firewall}
is the name of the firewall and {policy} is the name of the policy.
3. Configure the following parameter(s) as required:
Parameter
predefined-zone { predefined-zone }
all
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 6.9.12.4
Configuring the Destination Zone
To configure the destination zone for a firewall policy, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the following parameter(s) as required:
Parameter
predefined-zone { predefined-zone }
all
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 6.9.12.5
Deleting a Policy
To delete a policy, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the policy by typing:
200
(Optional) The description string for this policy.
Zone".
Synopsis: A string
Synopsis: A string
Description
Section 6.9.12.3, "Configuring the
Section 6.9.12.4, "Configuring
Description
Description
Configuring the Source Zone
RUGGEDCOM ROX II
CLI User Guide