Table of Contents
Advertisement
Single II will ask for the PUC code to enable the card again. The
CryptoCard allows for four invalid PUC code entries. After the fifth
invalid PUC code entry the Single II will disable the card definitively. It is
advised to keep the PUC code in a safe place.
10.3 Making an encrypted recording
To make encrypted recordings it is essential that the Use CryptoCard
function is enabled in the Recorder Settings menu. Enable the Use
CryptoCard function as described in § 12.4.1. With Use CryptoCard
enabled it is no longer possible to make normal, unencrypted recordings
without disabling the Use CryptoCard function again.
• Insert the CryptoCard in the card reader of the Single II.
Friday
Card inserted
When a valid CryptoCard has been inserted all recordings made
thereafter will be encrypted as long as the card remains inserted.
NOTE: Removing the card disables recording automatically.
NOTE
NOTE
NOTE
Encrypted recordings are stored as such and can be played only
with a matching CryptoCard inserted. Encrypted recordings can
also be played with a PC with the Single II software; however,
they cannot be played on the PC without a CryptoCard matching
the card used when the recording was made. See the following
section for a detailed explanation.
10.4 Playing an encrypted recording
Encrypted recordings can only be played back with the original or a
matching CryptoCard. For playback of an encrypted recording on the
Single II this works quite simply. Search and select the desired recording
as described in Chapter 5. If playback of the encrypted recording is
started the Single II will automatically ask for the Card code.
Card Code : 4
After entering your PIN code the menu key function CONTINUE
in the display.
• Press CONTINUE
CONTINUE to start playback of the selected recording.
CONTINUE
CONTINUE
46
Manual Call Recorder Single II © 2011-2014 Vidicode®
01-07-14 11:54
CANCEL
CONTINUE is added
CONTINUE
CONTINUE
Advertisement
Table of Contents
Need help?
Do you have a question about the Call Recorder Single II and is the answer not in the manual?
Questions and answers
we try call in but caller number no appear
The caller number may not appear on the Vidicode Call Recorder Single II due to several possible reasons:
1. Caller ID Not Enabled: The device may not have Caller ID functionality enabled in its settings.
2. Unsupported Phone Line: The telephone line may not support Caller ID transmission.
3. Signal Issues: Poor signal quality or interference could prevent the caller number from being detected.
4. Incorrect Configuration: The recorder may not be properly configured to capture Caller ID information.
5. Blocked Caller ID: The caller may have blocked their number from being displayed.
6. Compatibility Issues: Some telephone models may not transmit Caller ID in a format compatible with the recorder.
Checking the device settings and ensuring Caller ID is supported and enabled can help resolve the issue.
This answer is automatically generated