Table of Contents
Advertisement
7.2
Handset
An external handset can be purchased as an option. With the handset
connected, and the Single II configured with Telephone mode: ON
External handset: ON
regular telephone.
7.3 Starting a call
There are three ways to start a call.
- Pick up the handset,
- Press the Hook control function key,
- Open the phone book and select a telephone number, and then
push the hook-control or lift the handset.
Push the hook-control function key
•
tone.
Number: _
Enter the number and wait for the remote phone to ring.
•
It is also possible to use the Single II entering the number first, before
the handset is picked up or the Hook-control pushed. :
First enter the number.
•
Number: 0791234567_
STORE
Then push the hook-control function key
•
(If you were to press STORE, the phonebook will open and the number
can be stored together with the Name.)
Dial: 0791234567
The number is dialled
34
Manual Call Recorder Single II © 2011-2014 Vidicode®
ON (See also § 12.3) The Single can be used as a
ON
ON
CLEAR
and wait for the dial
REPEAT
STOP
ON,
ON
ON
Advertisement
Table of Contents
Need help?
Do you have a question about the Call Recorder Single II and is the answer not in the manual?
Questions and answers
we try call in but caller number no appear
The caller number may not appear on the Vidicode Call Recorder Single II due to several possible reasons:
1. Caller ID Not Enabled: The device may not have Caller ID functionality enabled in its settings.
2. Unsupported Phone Line: The telephone line may not support Caller ID transmission.
3. Signal Issues: Poor signal quality or interference could prevent the caller number from being detected.
4. Incorrect Configuration: The recorder may not be properly configured to capture Caller ID information.
5. Blocked Caller ID: The caller may have blocked their number from being displayed.
6. Compatibility Issues: Some telephone models may not transmit Caller ID in a format compatible with the recorder.
Checking the device settings and ensuring Caller ID is supported and enabled can help resolve the issue.
This answer is automatically generated