Table of Contents
Advertisement
Use the existing telephone line of the telephone to connect the Single II
to the telephone line wall socket. The telephone line is connected to the
Phone Line In port.
Use the supplied flat cable with two RJ11 connectors to connect the
telephone to the Call recorder. Connect the cable to the Phone Line
port on the Single II.
4.1.1
Configure Record from Line
• Press the
Record from:
NEXT
• Press CHANGE to select "Line".
• Press NEXT
NEXT to move to the Start method setting:
NEXT
NEXT
Start:
NEXT
• Press CHANGE
CHANGE to select "Series Off Hook".
CHANGE
CHANGE
Other Start Method options are:
-
Parallel Off Hook
-
Series + Parallel
-
Voice Activated
-
Close Contact
-
Manually
These options can be used in deviant configurations.
• Press STOP
STOP to quit the settings menu or continue with the settings
STOP
STOP
in § 12.3.
24
Manual Call Recorder Single II © 2011-2014 Vidicode®
Configuration function key to enter the settings.
Configuration
Configuration
Configuration
Line
CHANGE
Series off-hook
CHANGE
STOP
STOP
Line Out
Line
Line
Out
Out
Out
Advertisement
Table of Contents
Need help?
Do you have a question about the Call Recorder Single II and is the answer not in the manual?
Questions and answers
we try call in but caller number no appear
The caller number may not appear on the Vidicode Call Recorder Single II due to several possible reasons:
1. Caller ID Not Enabled: The device may not have Caller ID functionality enabled in its settings.
2. Unsupported Phone Line: The telephone line may not support Caller ID transmission.
3. Signal Issues: Poor signal quality or interference could prevent the caller number from being detected.
4. Incorrect Configuration: The recorder may not be properly configured to capture Caller ID information.
5. Blocked Caller ID: The caller may have blocked their number from being displayed.
6. Compatibility Issues: Some telephone models may not transmit Caller ID in a format compatible with the recorder.
Checking the device settings and ensuring Caller ID is supported and enabled can help resolve the issue.
This answer is automatically generated