The Cryptocard And Its Pin And Puc Code; Making An Encrypted Recording - Vidicode 010.01830 Manual

8.3 The CryptoCard and its PIN and PUC code

The CryptoCard is supplied with a PUC code and a PIN code. The PIN
code is a four-digit code and is requested to enable playback of
recordings. The PUC code is a twelve-digit code and is used only when
the card has been disabled. The PIN code can be changed with the Call
Recorder. This can be done only when the Use CryptoCard function has
been enabled. See § 4.2 to enable the use of a CryptoCard.
Press the
•
Press SYSTEM SYSTEM SYSTEM SYSTEM
•
Press NEXT NEXT NEXT several times. NEXT
•
Change Card Code
NEXT
Press CHANGE CHANGE to change the card code. CHANGE CHANGE
•
First enter the original card code.
Press CONTINUE.
•
Enter the new card code.
Press CONTINUE.
•
Repeat the new card code for confirmation.
Press CONTINUE.
•
NOTE! NOTE! NOTE! NOTE!
A CryptoCard allows for two invalid PIN code entries. After the third
invalid Pin code entry the CryptoCard is disabled. The next time the Call
Recorder will ask for the PUC code to enable the card again. The
CryptoCard allows for four invalid PUC code entries. After the fifth
invalid PUC code entry the Call Recorder will disable the card
definitively. It is advised to keep the PUC code in a safe place.

8.4 Making an encrypted recording

To make an encrypted recording it is essential that the Use CryptoCard
function is enabled in the Recorder settings menu. Enable the Use
CryptoCard function as described in § 4.2. With Use CryptoCard enabled
it is no longer possible to make normal, unencrypted recordings without
disabling the Use CryptoCard function again.
52 Call Recorder PRI manual © 2009-2014 Vidicode®
function key
CHANGE STOP