Vidicode Call Recorder Single II Manual page 60

Hide thumbs Also See for Call Recorder Single II:

Manual (29 pages)

Table Of Contents

Table of Contents

The Start level can be moved with the <<

The Stop level can be moved with the <<

The "S" indicates the start level for recording, the "X" indicates the stop

level to stop recording.

Pick up the connected telephone and the signal of the dial tone will be

displayed as a black bar:

A1»»»X X X X »»»S S S S »»»»»...........

For the Call Recorder to start recording the displayed audio level needs

to exceed the "S" sign as is the case in the example above. Adjust the

start level by pressing the soft-keys below the << and >> in the

display. It is advised to set the start level approximately three units

below the actual audio level of the dial tone.

To stop the recording the audio level needs to fall below the cross sign

("x"). Adjust the stop level with the

advised to keep the stop level approximately three units above the

actual audio level the Call Recorder is supposed to stop on. For the Call

Recorder to actually stop recording the audio level needs to fall below

the set stop level for a certain amount of time. This amount of time is

called the Silence Period.

Press Back

Back when the Start and Stop levels have been set.

Back

•

When set the next menu item will be "Silence Period", which is used to

detect a remote hang-up in case there is no normal disconnect tone

The Silence period setting is located in the Recorder Settings menu. See

§ 12.4.9

Start with a relatively short Silence timeout of 5 seconds and begin

varying the Start and Stop level. Begin with a relatively low Start level

where the dial tone will start a recording and where speaking in the

handset will keep the recording to continue longer then the 5 seconds

of the Silence timeout.

Then start raising the Stop level until you find a setting where not

speaking into the handset actually stops the recording after the 5

seconds of the silence timeout.

<< and >>

>> menu

menu keys.

>> recorder

recorder keys.

recorder

BACK

and

recorder keys. It is

Table of Contents

Need help?

Do you have a question about the Call Recorder Single II and is the answer not in the manual?

Questions and answers

Stella Teo

January 23, 2025

we try call in but caller number no appear

1 comments:

Mr. Anderson

February 10, 2025

The caller number may not appear on the Vidicode Call Recorder Single II due to several possible reasons:

1. Caller ID Not Enabled: The device may not have Caller ID functionality enabled in its settings.
2. Unsupported Phone Line: The telephone line may not support Caller ID transmission.
3. Signal Issues: Poor signal quality or interference could prevent the caller number from being detected.
4. Incorrect Configuration: The recorder may not be properly configured to capture Caller ID information.
5. Blocked Caller ID: The caller may have blocked their number from being displayed.
6. Compatibility Issues: Some telephone models may not transmit Caller ID in a format compatible with the recorder.

Checking the device settings and ensuring Caller ID is supported and enabled can help resolve the issue.