Using The Keypad Control Menu; Finding The Keypad Control Menu - Danfoss Vacon NXP Series Operating Manual

Operating guide | VACON® NXS/NXP Air-cooled
When the drive is in RUN state, many parameters are locked, and cannot be edited. Only the text Locked shows on the display. Stop the
AC drive to edit these parameters.
Procedure
1. Find the parameter with the Browser and Menu buttons.
Min Frequency
2. To go to the Edit mode, push the Menu button Right. The parameter value starts to blink.
Min Frequency
3. Push the Menu button Right. The value can now be edited digit by digit.
4. To accept the change, push the [enter] button.
To ignore the change, push Menu button Left many times, until the view goes back to the parameter list.
If the [enter] button is pushed, the value stops to blink and the new value shows in the value field.
Min Frequency
5. For locking the parameter values, use the Parameter Lock function in menu M6, see

8.4 Using the Keypad Control Menu

8.4.1 Finding the Keypad Control Menu

Context:
In the Keypad control menu, the following functions are available: selecting the control mode, editing the frequency reference, and
changing the direction of the motor.
90 | Danfoss A/S © 2018.06
READY
Keypad
13.95 Hz
READY
Keypad
13.95 Hz
READY
Keypad
14.45 Hz
Using the Control Panel
8.7.6.6 Locking a Parameter.
DPD00910G