Danfoss Vacon NXP Series Operating Manual page 10

Operating guide | VACON® NXS/NXP Air-cooled
Procedure
1. Check that the delivery agrees to the order, see
2. Before starting the commissioning, read carefully the safety instructions in
3. Before the mechanical installation, check the minimum clearances around the AC drive (
Cooling of Standalone AC drives (FR10 to
4. Check the dimensions of the motor cable, mains cable, mains fuses and check the cable connections. Read
6.2 EMC-compliant Installation
5. Obey the installation instructions, see
6. Find information on the control connections in
7. If the start-up wizard is active, select the language of the control panel and the application. Accept the selections with the Enter
button. If the start-up wizard is not active, obey the instructions a and b.
A Select the language of the control panel from the Menu M6, page 6.1. For instructions, see
B Select the application from the Menu M6, page 6.2. For instructions, see
8. All parameters have factory default values. To make sure that the AC drive operates correctly, make sure that these group G2.1
parameters have the same data as the nameplate. For more information on the parameters in the list, see the VACON
Application Manual.
• Nominal voltage of the motor
• Nominal frequency of the motor
• Nominal speed of the motor
• Nominal current of the motor
• Motor cos phi
9. Obey the commissioning instructions, see
®
The VACON NXS/NXP AC drive is ready for operation.
10 | Danfoss A/S © 2018.06
4.1 Checking the
FR11)) and check the ambient conditions in
and 6.3 Grounding.
6.5 Installing the Cables.
7.3.2 Control Terminals on
9.2 Commissioning the AC
Delivery.
2.2 Danger and Warnings
5.2.2 Cooling of FR4 to FR9
12.8 VACON NXP Technical
OPTA1.
8.7.4 Changing the
Drive.
Introduction
and 2.3 Cautions and
and 5.2.3
Data.
6.1 Cable Connections,
8.7.3 Changing the Language.
Application.
®
All in One
DPD00910G
Notices.