Editing The Values Digit By Digit - Danfoss Vacon NXP Series Operating Manual

Operating guide | VACON® NXS/NXP Air-cooled
Prerequisites:
When the drive is in RUN state, many parameters are locked, and cannot be edited. Only the text Locked shows on the display. Stop the
AC drive to edit these parameters.
Procedure
1. Use the Browser buttons Up and Down to find the parameter (P#) to edit. To move directly from the last parameter of a parameter
group to the first parameter of that group, push the Browser button Up.
Min Frequency
2. To go to the Edit mode, push the Menu button Right. The parameter value starts to blink.
Min Frequency
3. Set the new value with the Browser buttons Up and Down.
4. To accept the change, push the [enter] button or ignore the change with menu button Left.
If the [enter] button is pushed, the value stops to blink and the new value shows in the value field.
Min Frequency
5. For locking the parameter values, use the Parameter Lock function in menu M6, see

8.3.3 Editing the Values Digit by Digit

Context:
Use these instructions to edit the numerical values on the control panel.
The basic application package "All in One+" includes 7 applications with different sets of parameters. For more information, see
®
VACON All in One Application Manual.
Prerequisites:
Danfoss A/S © 2018.06
READY
Keypad
13.95 Hz
READY
Keypad
13.95 Hz
READY
Keypad
14.45 Hz
Using the Control Panel
8.7.6.6 Locking a Parameter.
DPD00910G | 89