Using The Active Faults Menu (M4); Finding The Active Faults Menu - Danfoss Vacon NXP Series Operating Manual

Operating guide | VACON® NXS/NXP Air-cooled
8.4.7.2 Copying the Frequency Reference Set to the Control Panel
Context:
These are special functions only available in menu M3.
Use these instructions to copy the frequency reference set from I/O or fieldbus to control panel.
Prerequisites:
Make sure to be in menu M3 and that the control mode is other than keypad.
Procedure
1. Keep the [enter] button pushed down for 3 s.
In other menu than M3, when the keypad is not the active control mode and the start button is pushed, an error message Keypad
Control NOT ACTIVE shows.

8.5 Using the Active Faults Menu (M4)

8.5.1 Finding the Active Faults Menu

Context:
The Active faults menu shows a list of active faults. When there are no active faults, the menu is empty.
For more information on the fault types and how to reset faults, see
Fault. For the fault codes, possible causes and information on how to correct the fault, see
94 | Danfoss A/S © 2018.06
11.1 General Information on Fault Tracing
12.10 Fault
Using the Control Panel
and 11.2 Resetting a
Codes.
DPD00910G