Danfoss Vacon NXP Series Operating Manual page 105

Operating guide | VACON® NXS/NXP Air-cooled
Procedure
1. In Security submenu, push the Menu button Right.
2. To go to the edit mode, push the Menu button Right.
The display shows 0 that blinks.
3. There are 2 options to set a password: with the Browser buttons or by digits. The password can be a number between 1 and 65535.
- With the Browser buttons: Push the Browser buttons Up and Down to find a number.
- By digits: Push the Menu button Right. A second 0 shows on the display.
• Push the Browser buttons to set digit on the right.
• Push the Menu button Left, and set the digit on the left.
• To add a third digit, push the Menu button Left. Set up to 5 digits with Menu and Browser buttons and set the digit for each
one with the Browser buttons.
4. To accept the new password, push the [enter] button.
The password activates after the Timeout time (P6.6.3) (see
8.7.6.4 Entering a Password
Context:
In a password-protected submenu, the display shows Password? Use these instructions to enter the password.
Procedure
1. When the display shows Password?, give the password with the Browser buttons.
8.7.6.5 Deactivating the Password Function
Context:
Use these instructions to deactivate the password protection for application selection menu.
Procedure
1. Find the Password (S6.5.1) in the Security menu with the Browser buttons.
2. To go to the edit mode, push the Menu button Right.
3. Set value 0 for the password.
8.7.6.6 Locking a Parameter
Context:
Use the Parameter lock function to prevent changes to the parameters. If the parameter lock is active, the text locked shows on the
display when trying to edit a parameter value.
This function does not prevent unauthorized changes of parameter values.
Danfoss A/S © 2018.06
8.7.7.4 Setting the Timeout
N O T I C E
Using the Control Panel
Time).
DPD00910G | 105