Operating guide | VACON® NXS/NXP Air-cooled
5. Connect the cables. See the correct tightening torques in
•
Connect the phase conductors of the mains cable and of the motor cable, and the conductors of the brake resistor cable into
the correct terminals.
6. Make sure to connect the grounding conductor to the motor and the terminals that are identified with the grounding symbol.
•
If a double grounding is necessary, use the grounding terminal below the drive. Use an M5 screw and tighten it to 2.0 Nm or
17.7 lb-in.
7. Attach the cable cover
12.5 Tightening Torques for Cover
M4x16 screws delivered in the accessories bag. Use these clamps to ground the control cables.
62 | Danfoss A/S © 2018.06
12.6 Tightening Torques of the
Screws. Attach the grounding clamps for control cable with 3 pieces of
Electrical Installation
Terminals.
DPD00910G