Display Settings For Windows; Display Settings For Linux - Hitachi CB 520H A1 User Manual

Windows
Linux
• [LPAR manager firmware version: 01-6X or later]
Windows
Linux

Display settings for Windows

Note:
• When using Windows Server 2012 or later in EFI boot, the recommended
display settings are "Screen resolution: 1024 by 768 pixels" and "Color
quality: Highest (32 bit)" on Guest OS.
Display settings cannot be changed.
Set "Screen resolution" to "1024 by 768 pixels", "Color quality" to "Medium
(16 bit)" (When setting 32 bit, set to "Highest (32 bit)") in the Display
Properties dialog box. Click OK.
When the dialog box to confirm is displayed, click Yes.

Display settings for Linux

Note:
• When setting a display using System > Administration > Display or
System > Preferences > Screen Resolution, the settings of resolution or
color quality might not be reflected normally, or the display might be
distorted after the resolution settings.
In that case, set the display using /etc/X11/xorg.conf.
Open /etc/X11/xorg.conf in an editor, and set the following settings.
1 Confirm that Section "Device" > Driver is vesa in /etc/X11/
.
xorg.conf.
When other than vesa, set vesa.
Example of Section "Device" settings:
Section "Device"
Identifier "Videocard0"
Driver "vesa"
EndSection
5-64
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Table 5-7 Recommended display settings
Guest OS
1024 x 768 pixels
1024 x 768 pixels
Table 5-8 Recommended display settings
Guest OS
1024 x 768 pixels
1024 x 768 pixels
Setup of LPAR manager
Screen resolution
Screen resolution
Color quality
16 bit
16 bit
Color quality
32 bit
24 bit