Hitachi CB 520H A1 User Manual page 271

No. Item
(4) Core# Displays the core number in the die.
(5) Thread# Displays the thread number.
(6) State Display status of a core.
ACT (Activate): Normal state
(7) Status Displays the status of the physical
processor.
HIG: The physical processor is possible to
run at the highest rate.
The current clock frequencies of physical
processors might not run at the maximum
rate when a power capping function is
enabled, Turbo Mode is enabled or
processors are idle.
MXX: The physical processor is possible to
run at a
moderate.
M01 is the fastest; as the number of a
processor increases, its rate decreases.
LOW: The physical processor is running at
the lowest rate
FAI: The physical processor is in failure
state.
ERR: The physical processor is in error
state.
OFF: The physical processor is in off-line.
(8) Group# Sets the number of a processor group.
(9) Schedule S: Indicates that the physical processor can
be used by the LPAR in shared mode.
D: Indicates that the physical processor is
used by the LPAR in dedicated mode.
(10) Freq(GHz) Displays the current clock frequencies of
the physical processor.
The current clock frequencies of physical
processors might not run at the maximum
rate when a power capping function is
enabled, Turbo Mode is enabled or
processors are idle.
(11) Node# Displays the Node number of a physical
processor.
'-' is displayed when Non-NUMA setting is
set.
(12) Group# Displays the number of a processor group.
(13) Name Sets a processor group name.
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Description
Supported
Default LPAR
Value manager
Version
- 01-0X~
- 01-0X~
- 01-0X~
- 01-0X~
0 01-0X~
D 01-0X~
- 01-0X~
- 01-2X
0 01-0X~
NO_NAME 01-0X~
7-33