Hitachi CB 520H A1 User Manual page 389

Message Content
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Failed to save LP configuration
Check the Internal Path State on the system service state screen.
If Link is shown as No or Connect as Fail, check the internal LAN
switch settings.
Go to Shared FC Assign on Type=F & Schd=S.
The device is a shared FC, so you need to change it on the
Shared FC Assignment screen.
Aborts the specified process.
Make the setting on the Shared FC Assignment screen.
Go to VNIC Assign on Type=N & Schd=S.
The device is a shared NIC, so you need to change it on the
Virtual NIC Assignment screen.
Aborts the specified process.
Make the setting on the Virtual NIC Assignment screen.
Guest operating system may not remove USB device(s)
safely. Force to detach.
Indicates that connecting or disconnecting the device has failed.
If activating the LPAR, stops activation. If changing the device
target, stops connecting or disconnecting the device.
Assign the USB device to the LPAR again.
LP cannot activate LPAR due to safe mode.
The LPAR cannot be activated because the safe mode is on.
Aborts the specified process.
Release the safe mode and then perform the operation again.
LP cannot save configuration due to safe mode.
The configuration information cannot be saved because the safe
mode is on.
Aborts the specified process.
Release the safe mode and then perform the operation again.
Messages
9-13