Lp Communication Settings; Dns - Hitachi CB 520H A1 User Manual

LP communication settings

Specify the port number to be used for communication between LPAR
manager and management module.
All LPAR managers in the server chassis use the same port number. You
cannot use a different port number for an individual LPAR manager.
Before you change the setting, make sure that all server blades for which
Logical partitioning is set to Enable.
Firmware combinations
Server blade
CB 520H B3
CB 520H B4
CB 520X B1
CB 520X B2
CB 520X B3
Note:
• To set port numbers, the firmware combination of all the server blades
whose Logical Partitioning is set to Enabled must be a combination that
supports this function. If the firmware combination does not support this
function, port numbers cannot be set.
Specifying LP communication settings
To specify LP communication settings, perform the operations described
below from the Web console.
LP communication settings

DNS

LPAR manager supports name resolution by using a DNS. You can specify
some servers that link to LPAR manager by using host names.
Supported version
Management Module firmware
2-20
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Server blade
firmware
08-35 or later
10-03 or later
07-34 or later
09-17 or later
11-07 or later
Item
Item
System Operation
Management Module
firmware
A0260 or later
A0305 or later
A0260 or later
A0270 or later
A0320 or later
Operation
Resources tab > Systems > LP
communication settings
A0280 or later
LPAR manager
firmware
02-25 or later
02-50 or later
02-25 or later
02-27 or later
02-56 or later
Version