Hitachi CB 520H A1 User Manual page 346

No.
(11)
(12)
(13)
(14)
(15)
(16)
7-108
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Item
regardless of the combination of
firmware versions.
Take LP Dump Collects the LPAR manager dump.
The LPAR manager dump collected with
this operation is used to analyze
failures when they occur.
In normal operation, there is no need to
collect the LPAR manager dump. If a
problem appears in the equipment, it
may become necessary to collect the
LPAR manager dump.
Activation Specifies the display of a confirmation
prompt sub-screen when activating an
LPAR from the LPAR manager screen.
Yes: Displays the confirmation prompt
sub-screen.
No: Does not display the confirmation
prompt screen.
Deactivation Specifies the display of a confirmation
and prompt sub-screen when deactivating
Reactivation or reactivating an LPAR from the LPAR
manager screen.
Yes: Displays the confirmation prompt
sub-screen.
No: Does not display the confirmation
prompt screen.
Screen Sets the character used to switch from
Switching a guest screen to the LPAR manager
Character screen. "l" (the lower case "L") is set as
the default. You can use all lower case
letters except for b, h, i, j, m, g, s and
z.
Clear NVRAM Initializes the NVRAM of the LPAR
specified by (16).
This operation cannot be performed if
"Select" is displayed in (16). (The
cursor cannot move over this column.)
"Clear NVRAM" initializes the boot order
settings, but does not initialize the EFI
driver settings.
- Displays the LPAR on which the NVRAM
is to be initialized.
You can specify only a deactivated
LPAR. "Select" will be displayed if no
LPARs have been defined, or if LPARs
had been defined, but all LPARs have
been activated.
Operation by LPAR manager Screen
Description
Supported
Default LPAR
Value manager
Version
Execute 01-0X~
Yes 01-0X~
Yes 01-0X~
- 01-0X~
- 01-0X~
- 01-0X~