Deactivation Of Lpar; Shutdown Of Guest Os - Hitachi CB 520H A1 User Manual

2 If Section "Monitor" or Section "Screen" > Monitor line is not exist,
.
refer to the following examples to create the new line.
Set Section "Screen" > SubSection "Display" > Modes as 1024x768.
If Modes line is not exist, create the new line.
Set Section "Screen" > DefaultDepth or Section "Screen" >
SubSection "Display" > Depth as 16 (24 when set 24 bit).
Example of Section "Monitor" settings:
Section "Monitor"
EndSection
Example of Section "Screen" settings:
Section "Screen"
EndSubSection
EndSection
Restart the X server to reflect the screen resolution.

Deactivation of LPAR

Execute [Shutdown of guest OS] when OS is operating normally.

Shutdown of Guest OS

Execute (Enter) the Shutdown command. When the Shutdown processing is
finished, the LPAR is deactivated.
Deactivation of LPAR
Operation of LPAR deactivation corresponds to turning off power of Server
Blade. Therefore take care enough for executing deactivation.
Especially, the deactivation during OS data access may destroy the data. So,
be sure to execute OS shutdown before LPAR deactivation.
1 Deactivate a LPAR from the LPAR manager screen.
.
On the LPAR manager Menu or LPAR manager Menu or Logical
Partition Configuration screen, press F4 key for deactivation of LPAR.
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Identifier "Monitor0"
ModelName "LCD Panel 1024x768"
HorizSync 31.5 – 48.0
VertRefresh 26.0 – 65.0
Option "dpms"
Identifier "Screen0"
Device "Videocard0"
Monitor "Monitor0"
DefaultDepth 16
SubSection "Display"
Viewport 0 0
Depth 16
Modes "1024x768"
Setup of LPAR manager
<- "24" when set 24 bit
<- "24" when set 24 bit
5-65