Isdnswitch - Polycom VSX3000 Integrator's Reference Manual

Integrator's Reference Manual for the VSX Series

isdnswitch

4 - 150
Sets or gets the ISDN switch protocol. This command is only applicable if you
have an ISDN network interface connected to your system.
Syntax
isdnswitch get
isdnswitch <pt-to-pt_at&t_5_ess|multipoint_at&t_5_ess|ni-1>
isdnswitch <nortel_dms-100|standard_etsi_euro-isdn|ts-031|ntt_ins-64>
Parameter
get
pt-to-pt_at&t_5_ess|
multipoint_at&t_5_ess|
ni-1|nortel_dms-100|
standard_etsi_euro-isdn
|ts-031|ntt_ins-64
Feedback Examples
• isdnswitch pt-to-pt_at&t_5_ess
• isdnswitch multipoint_at&t_5_ess
• isdnswitch ni-1
• isdnswitch nortel_dms-100
• isdnswitch standard_etsi_euro-isdn
• isdnswitch ts-031
• isdnswitch ntt_ins-64
Comments
If more than one switch protocol is supported, you must find out from your
telephone service provider which protocol to select. If you change the country
settings, a new set of ISDN switch protocols is loaded.
User interface screen location: System > Admin Settings > Network > ISDN:
ISDN Switch Protocols
Description
Returns the current switch protocol.
Specifies the ISDN switch protocol to use.