Mechanical Installation; Necessary Tools And Instructions; Unpacking And Checking The Delivery; Installing The Module - ABB ACS580-07 Hardware Manual

242 Optional I/O extension modules
4 3-pin terminal block for transistor output
5 2-pin terminal block for external power supply
6 Diagnostic LED
￭

Mechanical installation

Necessary tools and instructions

• Screwdriver and a set of suitable bits.

Unpacking and checking the delivery

1. Open the option package.
2. Make sure that the package contains:
• CMOD-01 multifunction extension module
• mounting screw.
3. Make sure that there are no signs of damage.

Installing the module

See section Installing optional modules in chapter Electrical installation.
￭

Electrical installation

WARNING!
Obey the instructions in chapter Safety instructions. If you ignore them, injury or
death, or damage to the equipment can occur. If you are not a qualified electrician,
do not do electrical work.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for
5 minutes after disconnecting the input power.

Necessary tools and instructions

• Screwdriver and a set of suitable bits
• Cabling tools

Terminal designations

For more detailed information on the connectors, see section
Relay outputs
Marking
50 RO4C
51 RO4A
52 RO4B
53 RO5C
54 RO5A
55 RO5B
Description
Common, C
Normally closed, NC
Normally open, NO
Common, C
Normally closed, NC
Normally open, NO
Terminal designations (page 242)
Terminal designations (page 242)
LEDs (page 245)
Technical data (page 245).