Cabinet Layout - R8 And R9 (Bottom Entry And Exit Of Cables) - ABB ACS580-07 Hardware Manual

￭ Cabinet layout – R8 and R9 (bottom entry and exit of cables)
The cabinet layout of frame R9 with du/dt filter (option +E205) is shown below. Degree of
protection IP42 (option +B054). Frame R8 looks similar.
A
2
A Cabinet door closed
B Cabinet door open
C Cabinet door open, mounting plates and cabinet
shrouds removed
1 Drive control panel
2 Operating switch
3 Main switch handle
4 Gratings for cooling air in
5 Gratings for cooling air out
6
Mounting plate, see section
to R9 (page 30)
7 Lifting lugs
8 Cabinet door fan
9 Power and control cable entries
B
5
5
1
6
3
4
4
Mounting plate – R6
Operation principle and hardware description 29
7
16
15
14
13
12
11
8
10
9
10 Auxiliary voltage transformer T21
11 Input cable connection terminals
12 Main switch-disconnector (Q1)
13 AC fuses
14 Main contactor (Q2, option +F250)
15 Power cable connection terminals of the drive
module behind the shroud
16 Drive module
17 Additional I/O terminal block (option +L504)
18 Drive control unit
19 Common mode filter (option +E208)
20 du/dt filter (option +E205)
21 Motor cable connection terminals
Note:
For drives with no du/dt filter (option +E205), the
motor cables are connected to the drive module
terminals.
C
17
18
19
20
21